Messages

1

Video Splitter / Re: Sound problems

« on: May 29, 2009, 03:03:34 PM »

I can't log in per your instructions.  I'm clicking the link (I've tried both since there are two in my PM, both get me to same log in screen).  For username, I'm typing in the exact word you have after Log In -.  For password, I'm typing in exactly everything you have after Password -.  Maybe that's too literal but it seems to be what I am supposed to do.  Since there is both a dash & a comma in the password, I've even tried splitting that into a username & password at these two points but nothing will let me in.

Note: I'm actually trying to connect 23 clips, but even when I go with just 3 of them, the sound is off.

I've been working on this for a long while & found that many of the clips that I shortened with the Trimmer have the sound cut off before the video.  When joined with the Splitter these sounds "move left" on the video and the video delay decreases the more clips I put together.  I'm trying to just keep cutting the ending of each clip off until I finally get a copy where sound & video match.

2

Video Splitter / Sound problems

« on: May 28, 2009, 11:57:09 PM »

Now I've edited a bunch of clips with the Trimmer & the sound on all of them is sync'd with the picture.  However when I join several clips with the Splitter, the first couple clips are always sync'd, but the third is off, no matter which clip I use.  Again, the individual clips are all sync'd fine.  Any ideas?

3

Video Splitter / Re: Very basic batch question

« on: May 28, 2009, 05:36:49 PM »

Thanks, that did the trick!  I did have 2.2 downloaded, but the join manager isn't in manual, so the manual must be for previous version.

4

Video Splitter / Very basic batch question

« on: May 28, 2009, 04:12:43 PM »

This forum seems over my head.  I've saved several video clips using "Add task to batch queue A".  Now how do I watch all those clips in order?  I've tried "Start batch processing", thinking that might join them into one clip, but if it does I don't know where to find it.

I found the instructions are very clear about what each control does, but don't run thru each step with an example.